LPOD C- / Ku-Band Outdoor Amplifier/ Block Up Converter (BUC) Revision 3
Appendix B MN-LPOD
B–18
Parameter Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
(Note that all arguments are printable ASCII
characters)
Response to
Command
(Target to Controller)
Query
(Instruction
Code and
qualifier)
Response to
Query
(Target to
Controller)
IP Address IPA= 18 bytes Command or Query.
Used to set the IP address and network prefix for the
10/100 BaseT Ethernet management port, in the
format:
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Example: <1/IPA=192.168.001.004.24’cr’
>0001/IPA=’cr’’lf’
Note: Changing the IP address through the Telnet
interface requires the user to power cycle the unit, and
then restart a new Telnet session with the new IP
address. The IP address that you type into the Telnet
client software does not include the range parameter
so it would be: 192.168.1.4
Default Value: 192.168.001.004.24
IPA=
IPA?
IPA*
IPA#
IPA? IPA=
xx.xxx.xxx.xxx.yy
(See Description
of Arguments for
details)
Gateway Address IPG= 15 bytes Command or Query.
Used to set the Gateway IP address for the 10/100
Base Tx Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the IP address
Example: <1/IPG=192.168.001.005’cr’
>0001/IPG=’cr’’lf’
Default Value: 192.168.001.005
IPG=
IPG?
IPG*
IPG? IPG =
xxx.xxx.xxx.xxx
Initialize Statistics
Pointer
ISP= None Command only.
Resets internal pointer to allow RNS? Queries to start
at the beginning of the stored statistics log.
Example: <1/ISP=’cr’
>0001/ISP=’cr’’lf’
ISP=
ISP?
ISP*
N/A N/A
LNB Current
Source
LCS= 1 byte Command or Query.
This command enables, or disables the LNB current
source.
Note: LCS must be enabled before the LNB current
can be calibrated.
0 = Disable
1 = Enable
Example: <1/LCS=1’cr’
>0001/LCS=’cr’’lf’
Default Value: 0
LCS=
LCS?
LCS*
LCS? LCS=x
(Same format as
command
arguments)
To Next Page
Loading...
