Condair Mk5 - Page 49

49
Mk5 Visual
ready
entry code
9999
entry code
8999
adjust level
language
English
Sprache
Deutsch
new data
entered
unchanged
ref.value rh [%]
045
ref.value rh [%]
045
XXXXXXXX
(Enter=Entry)
new data
not valid
Call-up of the setting level
WiththeCondairMk5innormaloperation:
• Simultaneouslydepressthekeys<B> and <A>.
Youarenowpromptedtoenterthefourdigitaccesscode“8808”. The digit on
thefarleftashes.
• Entertheaccesscode“8808”asfollows:
Changetherstdigitwiththekeys<B> and <A>.Acceptyourinputwiththe
key<C>.Thenextdigitstartstoash.
Repeat this step for the remaining digits.
Afteracceptanceofthelastdigit,theadjacentmessageappearsbrieyonthe
displaytoconrmthatyouareonthesettinglevel.Therstmenuitemthenap-
pears on the display.
Note: If you have entered an incorrect code the message “Incorrect Code” appears
brieyonthedisplay.Theunitthenreturnstothenormalservicemode.
To change the set values
The unit is on the setting level.
• Pressthekey<C>,ifyouwishtochangethecurrentsetting.
– Menu items with selected values
• Pressthekey<B> or <A>, in order to select the desired setting from the
list.
• Acceptyourinputwiththe<C> key.
– Menu item with numerical set value
Thedigitonthefarleftstartstoash.
• Pressthekey<B>, in order to reduce the value of the selected digit or
thekey<A>, in order to increase the value of the digit.
• Acceptyourentrywiththe<C> key.
Note:Ifthevaluetobeenteredisamulti-digitvalue,thenextdigitstarts
toash.Youcanchangethisdigitasdescribedabove.
Afterconrmingthelastdigit(numericalsetvalue)andtheselectedsetvalue,
theadjacentmessageappearsbrieyonthedisplaytoconrmthatyouhave
enteredanewvalue.Thentheselectedmenuitemappearsagain.
Note: If an invalid value has been entered in a numerical input, the adjacent
message appears.
Ifyouhaveexitedtheinputeldwiththekey<C>,withouthavingchangedthe
setvalue,theadjacentmessageappearsbrieyonthedisplay.Thenthedis-
play for altering the set value appears again.
The process of changing the value can be interrupted at any point by pressing
the <Menu> key.Thelaststoredsetvaluethenremainsunchanged.