Condair RM2 - Page 61

61Fault elimination
Warning Fault Message Possible causes Remedy
W250 –––
ExportFile The conguration le was not saved.
Note: The Condair RM continues to work normally.
The conguration le ("SpaEx-
portSettings.json") could not be
created on the local le system.
Make sure the local le system
is working properly.
W251 –––
ExportIncomplete Not all data records of the conguration le were saved.
Note: The Condair RM continues to work normally.
Not all conguration settings
could be stored in the con-
guration le ("SpaExportSet-
tings.json") on the internal le
system.
Make sure that the saving pro-
cess has not been interrupted or
that no components have been
removed from the CAN BUS.
W252 ––– Import File Downloading of the conguration le failed.
Note: The Condair RM continues to work normally.
The conguration le ("SpaEx-
portSettings.json") could not be
found or opened on the local le
system.
Make sure the conguration
le ("SpaExportSettings.json")
is present and has been saved
correctly.
W253 ––– Import Incompatible The conguration le to be downloaded is incompatible.
Note: The Condair RM continues to work normally.
Some parameters in the cong-
uration le ("SpaExportSettings.
json") are not supported.
Make sure that all components
of the CAN BUS are updated
with the latest software version
and that the conguration le
has not been manipulated.
W254 ––– Import Incomplete Not all data from the conguration le could be loaded.
Note: The Condair RM continues to work normally.
The conguration le ("SpaEx-
portSettings.json") to be down-
loaded has been exported with
an older rmware version.
A le export with the latest rm-
ware has to be done again.
A component has been re-
moved from the CAN BUS after
an export has been performed.
Check that all components are
connected correctly to the CAN
BUS.