Contex COUGAR 36 - Jumper Settings; Signal Leds on the SUC-Board; Hints

FSG/MTM/001 060511
44
3.7.6 Jumper Settings
No jumpers.
3.7.7 Signal LEDs on the SUC-Board
The three signal LEDs on the SUC-Board are for debugging purposes only. The ON/OFF
pattern displayed by these LEDs is not intended for general troubleshooting.
3.7.8 Hints
After replacement of SUC-Board:
As all scanner parameters are stored in the Flash Memory on the SUC-Board, the following
steps should be carried out after replacement of the SUC-Board:
• Download Firmware
• Run Scanner Maintenance
• Enter Serial Number of scanner into Flash Memory (SCANtest 6, Test 1). The serial
number of the scanner is found on the marking label on back of the scanner