EasyManuals Logo

Continuum Precision II Series User Manual

Continuum Precision II Series
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Chapter I Laser Safety Precautions
C
1-1996-0255 rev. b
Chapter I Laser Safety Precautions
Government and industry regulations
Continuums user information is in compliance with section 1040.10 of 21
CFR Chapter I, Subchapter J concerning Radiological Health published
by U.S. Department of Health & Human Services Center for Devices &
Radiological Health, 1988 and EN 60825-1, safety of lasers.
The American National Standards Institute (ANSI), a member of the
International Organization for Standardization (ISO) and the Interna-
tional Electrotechnical Commission (IEC), has published a booklet on
laser safety standards. Continuum strongly suggests that all its customers
purchase a copy of the
American National Standard for the Safe Use of
Lasers in order to read and implement necessary precautions. Write or
call the publisher listed below for information on obtaining a copy of
ANSI Z136.1-1993.
Publisher: Laser Institute of America
13501 Ingenuity Drive
Suite 128
Orlando, FL 32826
Telephone +1(800) 345-2737
FAX: +1(407) 380-5588
e-mail: lia@laserinstitute.org
Web(Internet): http:/www.laserinstitute.org
CAUTION
Only operators experienced in working with lasers and
trained by a Continuum service engineer should use and
service the Powerlite Precision 9000 Laser, or the warranty
will be voided.
Laser safety precautions
The following is a summary of general safety precautions which are to be
observed by anyone working with the laser. For a complete listing of
safety standards see the ANSI booklet listed above.
1) This laser equipment must be located in a locked area with
access only to authorized personnel. The area must be marked
by well-defined warning signs, and off limits to unauthorized
personnel.
2) This laser equipment may only be operated by qualified person-
nel, who have also been trained by a Continuum customer
service engineer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Continuum Precision II Series and is the answer not in the manual?

Continuum Precision II Series Specifications

General IconGeneral
BrandContinuum
ModelPrecision II Series
CategoryMeasuring Instruments
LanguageEnglish