Corghi A 222 - INFLATING TYRES; INFLATING TUBELESS TYRES (TI VERSION ONLY)

102 Operator’s manual A 222
7.3.b. INFLATING TYRES
- Ensure the wheel is NOT
clamped on the turntable by the
clamps (Fig. 22).
- Move the horizontal arm fully
into the working position (Fig.
23)
- Lower the vertical arm to touch
the wheel (fig. 24), then lock the
arm in this position.
- Remove the valve core if it has not already been
removed (Fig. 25).
- Connect the air hose Doyfe inflator connector to
the valve stem (Fig. 26).
- Inflate the tyre by pressing the relative pedal
briefly and repeatedly, checking the pressure
gauge frequently to ensure that the pressure
NEVER exceeds the maximum pressure speci-
fied by the tyre manufacturer.
- Disconnect the inflation hose from the valve
stem.
- Move the manipulator arm away from the wor-
king position.
- Remove the wheel from the tyre changer.
7.3.c. INFLATING TUBELESS TYRES (TI
VERSION ONLY)
The TI version uses a power-
ful blast of air from nozzles
near the clamping grippers to
facilitate bead breaking and
inflation with tubeless tyres
NO
YES
22
24
23
25
26