Operator’s manual A 222 103
Before starting with the operations described below, make sure there is no dirt, dust
or other impurities near the inflation nozzles.
- Check that both the upper and lower beads and
the rim bead seat have been suitably lubricated
with approved paste for mounting.
- Move the horizontal arm fully into the working
position (Fig. 28)
- Ensure that the wheel is clamped onto the turntable
from the inner side (fig. 29).
- Lower the vertical arm to touch the wheel (fig. 24),
then lock the arm in this position
- Remove the valve core if it has not already been
removed (Fig. 29).
- Connect the air hose Doyfe inflator connector to
the valve stem (Fig. 30).
CAUTION
27
28
24
29
30
To increase the effectiveness of the inflation jets, always liberally lubricate beads
and raise the lower bead while activating inflation jets (Fig. 31).
NOTICE
- Fully depress the inflation tyre briefly (fig. 32). The tyre expands, pushing the beads
into the seating position.
To Next Page