Crestron Prodigy System User Manual

Crestron PTL4 Prodigy
®
System
• AUTO: In Auto mode, the thermostat allows the system to switch
between Heat and Cool automatically as needed to maintain the
setpoint temperature. On the P-TSTATRF, the display will show the
“flame” and “snowflake” icons.
To set a controlled zone’s system mode with the PTL4:
1. Select the zone to be controlled as described on page 56.
2. Touch MODE until the desired setting is displayed.
NOTE: Not all modes are available for all HVAC zones.
Fan Control
A zone’s fan can be set for automatic operation (Auto) or constant operation
(On). When set to AUTO, the fan will run when the system is cooling or
warming the controlled zone. When set to ON, the fan will always run. To set
a controlled zone’s fan setting with the PTL4:
1. Select the zone to be controlled as described on page 56.
Climate Controls
2. Touch FAN until the desired setting is displayed.
System User Guide – DOC. 7007B Prodigy System: PMC2 • 59

Crestron Prodigy System Specifications

General

Brand	Crestron
Model	Prodigy System
Category	Control Systems
Language	English