6.5 Disassemble and assemble the adapter
A
utoclaving
If the adapter is going to be autoclaved it must be disassembled in its parts. This
section shows how to disassemble and assemble the adapter.
Disassemble the adapter
The instructions below show an example how to disassemble the adapter.
Note:
The instructions show a BPG 300 column but is applicable to other BPG
c
olumns.
Step Action
1 Remove the adapter from the column tube according to instructions in
R
emove the adapter, on page 82.
2 Remove the adapter screw bolts.
3 Lift off the adapter top plate and adapter screws. Take care not to bend the
i
nlet tube.
4 The top plate assembly can be disassembled by removing the screws.
6 Maintenance
6
.5 Disassemble and assemble the adapter
BPG Columns Operating Instructions 29193223 AB 101
To Next Page
Loading...
