Basic Configuration
32
DWC-1000 Wireless Controller User’s Guide
Basic Configuration Step #1. Enable DHCP Server (Optional)
By default, Dynamic Host Configuration Protocol (DHCP) is disabled in the wireless
controller. If you are not configuring your access points with static IP addresses, set up a
DHCP server or DHCP server relay on the network. If desired, perform the following
procedure to configure your wireless controller to act as a DHCP server.
1. Click SETUP > Network Settings > LAN Setup Configuration. The LAN SETUP page
appears.
2. Under LAN IP Address Setup, change the IP Address and Subnet Mask to values used
within your network. Record the settings below; you will refer to them later in this
procedure:
– IP address: ___________________________________________
– Subnet mask: _________________________________________
3. Click Save Settings.
4. Wait 60 seconds, and then start your web browser.
To Next Page
Loading...
