D-Link UAP Software User Manual
12/10/09
Page 124 Clustering Access Points 34CSFP6XXUAP-SWUM100-D13
CLUSTERING ACCESS POINTS
This example shows how to configure a cluster with two APs and to enable automatic channel re-assigment.The location of
the local AP is Room 214, and the cluster name is MyCluster.
CLUSTERING APS BY USING THE WEB INTERFACE
1. Log onto the AP and navigate to the Cluster > Access Points page.
2. Enter the AP location and the name of the cluster for it to join.
3. Click Update.
4. Click Start Clustering to enable the clustering feature.
After you refresh the page, other APs that are on the same bridged segment, have radios in the same operating mode,
are enabled for clustering, and have the same cluster name appear in the Access Points table.
5. Go to the Channel Management page to view the channel assignments.
A table on the page displays the current channel assignments and the proposed channel assignments. The interval
setting in the Advanced section determine how often proposed changes are applied.
To Next Page
Loading...
