Software User Manual D-Link UAP
12/10/09
34CSFP6XXUAP-SWUM100-D13 Configuring the Ethernet Settings Page 23
USING THE CLI TO CONFIGURE ETHERNET SETTINGS
Use the commands shown in the following table to view and set values for the Ethernet (wired) interface. For more
information about each setting, see the description for the field in Table 12 on page 38.
Table 5: CLI Commands for Ethernet Setting
Action Command
Get the DNS Name get host id
Set the DNS Name set host id
<host_name>
For example:
set host id vicky-ap
Get Current Settings for the Ethernet (Wired) Internal
Interface
get management
Set the management VLAN ID set management vlan-id
<1-4094>
View untagged VLAN information get untagged-vlan
Enable the untagged VLAN set untagged-vlan status up
Disable the untagged VLAN set untagged-vlan status down
Set the untagged VLAN ID set untagged-vlan vlan-id
<1-4094>
View the connection type get management dhcp-status
Use DHCP as the connection type set management dhcp-client status up
Use a Static IP as the connection type set management dhcp-client status down
Set the Static IP address set management static-ip <ip_address>
Example:
set management static-ip 10.10.12.221
Set a Subnet Mask set management static-mask
<netmask>
Example:
set management static-mask 255.255.255.0
Set the Default
Gateway
set static-ip-route gateway
<ip_address>
Example:
set static-ip-route gateway 10.10.12.1
View the DNS Nameserver mode Dynamic= up
Manual=down
get host dns-via-dhcp
Set DNS Nameservers to Use Static IP Addresses
(Dynamic to Manual Mode)
set host dns-via-dhcp down
set host static-dns-1
<ip_address>
set host static-dns-2
<ip_address>
Example:
set host static-dns-1 192.168.23.45
Set DNS Nameservers to Use DHCP IP Addressing
(Manual to Dynamic Mode)
set host dns-via-dhcp up
To Next Page
Loading...
