Software User Manual D-Link UAP
12/10/09
34CSFP6XXUAP-SWUM100-D13 Configuring SNMPv3 Page 77
Section 6: Configuring SNMPv3
This section describes how to configure the SNMPv3 settings on the UAP and contains the following subsections:
• Configuring SNMPv3 Views
• Configuring SNMPv3 Groups
• Configuring SNMPv3 Users
• Configuring SNMPv3 Targets
The configuration pages for the features in this section are located under the SNMPv3 heading on the navigation tree of the
UAP Web UI.
CONFIGURING SNMPV3 VIEWS
A MIB view is combination of a set of view subtrees or a family of view subtrees where each view subtree is a subtree within
the managed object naming tree. You can create MIB views to control the OID range that SNMPv3 users can access.
A MIB view called "all" is created by default in the system. This view contains all management objects supported by the
system.
Figure 25: SNMPv3 Views
Table 35 on page 78 describes the fields you can configure on the SNMPv3 Views page.
Note: If you create an
excluded
view subtree, create a corresponding
included
entry with the same view name to
allow subtrees outside of the excluded subtree to be included. For example, to create a view that excludes the
subtree 1.3.6.1.4, create an
excluded
entry with the OID 1.3.6.1.4. Then, create an
included
entry with OID .1 with
the same view name.
To Next Page
Loading...
