D-Link UAP Software User Manual
12/10/09
Page 32 Viewing Associated Wireless Client Information 34CSFP6XXUAP-SWUM100-D13
VIEWING ASSOCIATED WIRELESS CLIENT INFORMATION
To view the client stations associated with a particular access point, click the Client Associations tab.
Figure 7: Viewing Client Association Information
The associated stations are displayed along with information about packet traffic transmitted and received for each station.
Table 10 describes the fields on the Client Associations page.
Table 9: Transmit/Receive
Field Description
Interface The name of the Ethernet or VAP interface.
Status Shows whether the interface is up or down.
MAC Address MAC address for the specified interface.
The UAP has a unique MAC address for each interface. Each radio has a different MAC
address for each interface on each of its two radios.
VLAN ID Virtual LAN (VLAN) ID.
You can use VLANs to establish multiple internal and guest networks on the same AP.
The VLAN ID is set on the VAP tab. (See “Configuring Load Balancing” on page 62.)
Name (SSID) Wireless network name. Also known as the SSID, this alphanumeric key uniquely
identifies a wireless local area network.
The SSID is set on the VAP tab. (See “Configuring Load Balancing” on page 62.)
Transmit and Receive Information
Total Packets Indicates total packets sent (in Transmit table) or received (in Received table) by this AP.
Total Bytes Indicates total bytes sent (in Transmit table) or received (in Received table) by this AP.
Total Drop Packets Indicates total number of packets sent (in Transmit table) or received (in Received table)
by this AP that were dropped.
Total Drop Bytes Indicates total number of bytes sent (in Transmit table) or received (in Received table) by
this AP that were dropped.
Errors Indicates total errors related to sending and receiving data on this AP.
To Next Page
Loading...
