Software User Manual D-Link UAP
12/10/09
34CSFP6XXUAP-SWUM100-D13 Setting the SSH Status Page 71
SETTING THE SSH STATUS
Secure Shell (SSH) is a program that provides access to the D-Link UAP CLI from a remote host. SSH is more secure than
Telnet for remote access because it provides strong authentication and secure communications over insecure channels.
From the SSH page, you can enable or disable SSH access to the system.
Under the Services heading, click the SSH tab and configure the settings as described in Table 31.
Figure 21: SSH Status
SETTING THE TELNET STATUS
Telnet is a program that provides access to the D-Link UAP CLI from a remote host. From the Telnet page, you can enable
or disable Telnet access to the system.
To set the Telnet status, click the Telnet tab under the Services heading and configure the settings as described in Table 32
on page 72.
Figure 22: Telnet Status
Table 31: SSH Settings
Field Description
SSH Status Choose to either enable or disable SSH access to the AP CLI:
• To permit remote access to the AP by using SSH, click Enabled.
• To prevent remote access to the AP by using SSH, click Disabled.
To Next Page
Loading...
