D-Link UAP Software User Manual
12/10/09
Page 114 Viewing Wireless Neighborhood Information 34CSFP6XXUAP-SWUM100-D13
Appendix A: Default AP Settings
When you first power on a UAP, it has the default settings shown in the following table.
Table 52: UAP Default Settings
Feature Default
System Information
User Name admin
Password admin
Ethernet Interface Settings
Connection Type DHCP
DHCP Enabled
IP Address 10.90.90.91 (if no DHCP server is available)
Subnet Mask 255.0.0.0
DNS Name None
Management VLAN ID 1
Untagged VLAN ID 1
IPv6 Admin Mode Enabled
IPv6 Auto Config Admin Mode Enabled
Radio Settings
Radio (1 and 2) On
Radio 1 IEEE 802.11 Mode 802.11a/n
Radio 2 IEEE 802.11 Mode 802.11b/g/n
802.11b/g/n Channel Auto
Radio 1 Channel Bandwidth 40 MHz
Radio 2 Channel Bandwidth 20 MHz
802.11a/n Channel Auto
Primary Channel Lower
Protection Auto
MAX Wireless Clients 200
Transmit Power 100 percent
Rate Sets Supported (Mbps) IEEE 802.11a: 54, 48, 36, 24, 18, 12, 9, 6
IEEE 802.11b: 11, 5.5, 2, 1
IEEE 802.11g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1
IEEE 5-GHz 802.11n: 54, 48, 36, 24, 18, 12, 9, 6
IEEE 2.4 GHz 802.11g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1
Rate Sets (Mbps)
(Basic/Advertised)
IEEE 802.11a: 24, 12, 6
IEEE 802.11b: 2, 1
IEEE 802.11g: 11, 5.5, 2, 1
EEE 5-GHz 802.11n: 24, 12, 6
IEEE 2.4 GHz 802.11n: 11, 5.5, 2, 1
Broadcast/Multicast Rate Limiting Disabled