Software User Manual D-Link UAP
12/10/09
34CSFP6XXUAP-SWUM100-D13 Configuring SNMPv3 Targets Page 81
CONFIGURING SNMPV3 TARGETS
SNMPv3 Targets send trap messages to the SNMP manager. Each target is identified by a target name and associated with
target IP address, UDP port, and SNMP user name.
Figure 28: SNMPv3 Target
SNMPv3 Users This field shows the users that you have defined on the AP. To remove a user, select the
user and click Remove.
Note: After you configure the SNMPv3 Users settings, you must click Apply to apply the changes and to save the
settings.
Table 38: SNMPv3 Targets
Field Description
IP Address Enter the IP address of the remote SNMP manager to receive the target.
Port Enter the UDP port to use for sending SNMP targets.
Users Enter the name of the SNMP user to associate with the target.To configure SNMP users, see
“Configuring SNMPv3 Users” on page 80.
SNMPv3 Targets This field shows the SNMPv3 Targets on the UAP. To remove a target, select it and click Remove.
Note: After you configure the SNMPv3 Target settings, you must click Apply to apply the changes and to save the
settings.
Table 37: SNMP v3 Users (Cont.)
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
