10D-Link DWR-961 User Manual
Section 3 - Conguration
Reconnect
Mode:
Choose whether to auto reconnect or manual reconnect if your
connection drops.
Maximum
Idle Time:
Specify maximum amount of time in seconds where connection
can remain idle.
Keep Alive: Choose whether to use ping to keep connection alive or to disable
this function.
Ping IP
Address:
If Keep Alive is enabled above, specify ip address to ping.
Ping Interval: Specify in seconds the time interval device will ping the address
above.
Radio
Frequency:
Check this box to enable cellular radios. If this box is unchecked,
the 3G/4G radios will be disabled.
WAN Ping
Enable:
Check this box to enable response when the router is pinged.
Roaming: Check this box to enable roaming of other networks.
Bridge
ethernet
ports:
Check this box to enable bridging between two networks.
NAT: Check this box to enable the NAT rewall function.
Transparent
Bridge:
Check this box to enable transparent bridge.
Click Apply to save your settings, or Cancel to revert to your previous settings.