D-Link Router - Queue Config

93D-Link DWR-961 User Manual
Section 3 - Conguration
Queue Cong
This screen lists all queues currently saved. Queues are assigned to specic network interfaces and assigned a precedence. The Queue entry can
then be used by QoS Classication to direct ingress packets accordingly. This section is intended for network professionals and advanced users
only, and can safely be ignored by a majority of users.
Name: Indicates the name of the queue.
Status: Indicates the status of the queue.
Key: Indicates the key or index of the queue.
Interface: Indicates the interface the queue applies to.
Algorithm: Indicates the algorithm employed by the queue.
Precedence: Indicates the precedent of packets sorted by the queue.
Shaping Rate
(bit):
Indicates the shaping rate set on the queue. -1 indicates no
shaping.
Ceiling Rate
(bit):
Indicates the ceiling rate set on the queue.
Percent: Indicates the percent of total bandwidth assigned to the queue.
Shaping Burst
Size:
Indicates maximum burst size permitted in the queue.
Action: Click the pencil (
) icon to edit the queue, click the trash can icon
( ) to delete the queue. Select the C icon to clone the queue.
Add: Click Add to add a new queue, described in Queue Cong - Add
on page 94.