D-Link xStack DES-3528 Series - Page 111

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
111
config bandwidth_control
Purpose
Used to configure bandwidth control on a port by-port basis.
Syntax config bandwidth_control [<portlist> | all] {rx_rate [no_limit | <value 64-1024000>] |
tx_rate [no_limit | <value 64-1024000>]}(1)
Description
This command is used to configure bandwidth on a port-by-port basis.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
rx_rate − Specifies that one of the parameters below (no_limit or <value 64-1024000>) will
be applied to the rate at which the above specified ports will be allowed to receive packets
 no_limit − Specifies that there will be no limit on the rate of packets received by the
above specified ports.
 <value 64-1024000> − Specifies the packet limit, in Kbps, that the above ports will
be allowed to receive.
tx_rate − Specifies that one of the parameters below (no_limit or <value 64-1024000>) will be
applied to the rate at which the above specified ports will be allowed to transmit packets.
 no_limit − Specifies that there will be no limit on the rate of packets transmitted by
the above specified ports.
 <value 64-1024000> − Specifies the packet limit, in Kbps, that the above ports will
be allowed to transmit.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure bandwidth control:
DES-3528:admin# config bandwidth_control 1-10 tx_rate 64
Command: config bandwidth_control 1-10 tx_rate 64
Success.
DES-3528:admin#
show bandwidth_control
Purpose
Used to display the bandwidth control table.
Syntax show bandwidth_control {<portlist>}
Description
This command displays the current bandwidth control configuration on the Switch, on a port-
by-port basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed.
Restrictions
None.
Example usage:
To display port bandwidth control table:
DES-3528:admin# show bandwidth_control 1-10
Command: show bandwidth_control 1-10
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
----- ---------- ---------- ---------------- ----------------
1 No Limit No Limit No Limit No Limit
2 No Limit No Limit No Limit No Limit
3 No Limit No Limit No Limit No Limit
4 No Limit No Limit No Limit No Limit
5 No Limit No Limit No Limit No Limit
6 No Limit No Limit No Limit No Limit