xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
28
Modify Banner and Prompt Commands
Administrator level users can modify the login banner (greeting message) and command prompt by using the
commands described below.
Command Parameters
config command_prompt [<string 16> | username | default]
config greeting_message {default}
show greeting_message
The Modify Banner and Prompt commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
config command prompt
Purpose
Used to configure the command prompt.
Syntax config command_prompt [<string 16> | username | default]
Description
This command is used to change the command prompt.
Parameters string 16 –The command prompt can be changed by entering a new name of no more that 16
characters.
username – The command prompt will be changed to the login username.
default – The command prompt will reset to factory default command prompt.
Restrictions
Only Administrator and Operator-level users can issue this command. Other restrictions
include:
• If the “reset” command is executed, the modified command prompt will remain
modified. However, the “reset config/reset system” command will reset the
command prompt to the original factory banner.
Example usage:
To modify the command prompt to “AtYourService”:
To Next Page
Loading...
Need help?
General