D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
386
Link Layer Discovery Protocol (LLDP) Commands
The Link Layer Discovery Protocol (LLDP) commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameters
enable lldp
disable lldp
config lldp message_tx_interval <sec 5 - 32768 >
config lldp message_tx_hold_multiplier < 2 – 10 >
config lldp tx_delay < sec 1 - 8192 >
config lldp reinit_delay < sec 1 - 10 >
config lldp notification_interval <sec 5-3600>
config lldp ports [<portlist> | all] notification [enable | disable]
config lldp ports [<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
config lldp ports [<portlist> | all] [mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable]]
config lldp ports [<portlist> | all] basic_tlvs [{all} | {port_description | system_name |
system_description | system_capabilities}(1)] [enable | disable]
config lldp ports [<portlist> | all] dot1_tlv_pvid [enable | disable]
config lldp ports [<portlist> | all] dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] | vlanid
<<vidlist> > ] [enable | disable]
config lldp ports [<portlist> | all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid
<vidlist> ] [enable | disable]
config lldp ports [<portlist> | all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp | stp }(1)]
[enable | disable]
config lldp ports [<portlist> | all] dot3_tlvs [{all} | {mac_phy_configuration_status | link aggregation
| power_via_mdi | maximum_frame_size}(1)] [enable | disable]
config lldp forward_message [enable | disable]
show lldp
show lldp mgt_addr {[ipv4 {<ipaddr>} | ipv6 {<ipv6addr>}]}
show lldp ports {<portlist>}
show lldp local_ports { <portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports {<portlist>}
config lldp_med fast_start
repeat_count
<value 1-10>
config lldp_med log state [enable | disable]
config lldp_med notification
topo_change ports
[<portlist> | all] state [enable | disable]
config lldp_med ports [<portlist> | all] med_transmit_capabilities [all | {capabilities | network_policy |
power_pse | inventory}] state [enable | disable]
show lldp_med

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English