D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
435
Web-based Access Control Commands
The Web-based Access Control commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
enable wac
disable wac
config wac authorization
attributes
{radius [enable | disable] | local[enable | disable]}(1)
config wac
clear_default_redirpath
config wac
default_redirpath
<string 128>
config wac method [local | radius]
config wac ports [<portlist> | all] {state [enable | disable ] | aging_time [infinite | <min 1-1440>] |
idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)
config wac
switch_http_port
<tcp_port_number 1-65535> {[http | https]}
config wac user <username 15> [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] | clear_vlan]
config wac virtual_ip {<ipaddr> | <ipv6addr>}
show wac auth_state ports {<portlist>}
create wac user <username 15>{[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
delete wac user [user <username 15> | all_user]
show wac
show wac ports {<portlist>}
show wac user
clear wac auth_state [ports [<portlist> | all] {authenticated | authenticating | blocked} | macaddr
<macaddr>]
Each command is listed, in detail, in the following sections.
enable wac
Purpose
Used to enable the WAC function.
Syntax enable wac
Description
This command will enable the WAC function.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To enable the WAC function:
DES-3528:admin# enable wac
Command: enable wac
Success.
DES-3528:admin#

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English