D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
603
Appendix D - RADIUS Attributes Assignment
The RADIUS Attributes Assignment on the Switch is used in the following modules: 802.1X (Port-based and Host-
based), Japanese Web-based Access Control, Web-based Access Control, and MAC-based Access Control.
The description that follows explains the following RADIUS Attributes Assignment types:
• Ingress/Egress Bandwidth
• 802.1p Default Priority
• VLAN
• ACL
To assign Ingress/Egress bandwidth by RADIUS Server, the proper parameters should be configured on the
RADIUS Server. The tables below show the parameters for bandwidth.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute Description Value Usage
Vendor-ID Defines the vendor. 171 (DLINK) Required
Vendor-Type Defines the attribute. 2 (for ingress bandwidth)
3 (for egress bandwidth)
Required
Attribute-Specific Field Used to assign the bandwidth
of a port.
Unit (Kbits) Required
If the user has configured the bandwidth attribute of the RADIUS server (for example, ingress bandwidth 1000Kbps)
and the 802.1X authentication is successful, the device will assign the bandwidth (according to the RADIUS server) to
the port. However, if the user does not configure the bandwidth attribute and authenticates successfully, the device
will not assign any bandwidth to the port.
If the bandwidth attribute is configured on the RADIUS server with a value of “0”, the effective bandwidth will be set to
“no_limited”.
If the bandwidth attribute is configured to be less than “0” or greater than the maximum supported value, the effective
bandwidth will be ignored.
To assign 802.1p default priority by RADIUS Server, the proper parameters should be configured on the RADIUS
Server. The tables below show the parameters for 802.1p default priority.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute Description Value Usage
Vendor-ID Defines the vendor. 171 (DLINK) Required
Vendor-Type Defines the attribute. 4 Required
Attribute-Specific Field Used to assign the 802.1p default
priority of the port.
0-7 Required