D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
585
Command Logging Commands
The Command Logging Commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
enable command logging
disable command logging
show command logging
Each command is listed, in detail, in the following sections.
enable command logging
Purpose
This command is used to enable the command logging function.
Syntax enable command logging
Description
When the switch is under the booting procedure and the procedure of downloading the
configuration to execute immediately, all configuration commands should not be logged.
When the user is under AAA authentication, the user name should not changed if user uses
“enable admin” command to replace its privilege.
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To enable the command logging function:
DES-3528:admin#enable command logging
Command: enable command logging
Success.
DES-3528:admin#
disable command logging
Purpose
This command is used to disable the command logging function.
Syntax disable command logging
Description
This command is used to disable the command logging function.
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To disable the command logging:
DES-3528:admin#disable command logging
Command: disable command logging
Success.
DES-3528:admin#

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English