xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
177
Basic IP Commands
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> |
proxy_arp [enable | disable] {local [enable | disable]} | state [enable | disable]}
| bootp | dhcp | ipv6 [ipv6address <ipv6networkaddr> | state [enable | disable]]
| ipv4 state [enable | disable] | dhcpv6_client [enable | disable] |
dhcp_option12 [hostname <hostname 63> | clear_hostname | state [enable |
disable]]]
create ipif <ipif_name 12> {<network_address>} <vlan_name 32> {state [enable | disable]
| proxy_arp[enable | disable] {local [enable | disable]}}
delete ipif [<ipif_name 12> {ipv6address <ipv6networkaddr>} | all]
show ipif {<ipif_name 12>}
enable ipif [<ipif_name 12> | all]
disable ipif [<ipif_name 12> | all ]
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
disable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
show ipif_ipv6_link_local_auto {<ipif_name 12>}
Each command is listed, in detail, in the following sections.
To Next Page
Loading...
Need help?
General