D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
140
Voice VLAN Commands
The voice VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
enable voice_vlan [vlan <vlan_name 32> | vlanid <vlanid 1-4094>]
disable voice_vlan
config voice_vlan priority <int 0-7>
config voice_vlan oui [add | delete] <macaddr> < macmask> {description <desc 32>}
config voice_vlan ports [<portlist> | all] [state [enable | disable] | mode [auto | manual]]
config voice_vlan
aging_time
<min1-65535>
config voice_vlan log state [enable | disable]
show voice_vlan
show voice_vlan oui
show voice_vlan ports {<portlist>}
show voice_vlan
voice_device ports
{<portlist>}
Each command is listed, in detail, in the following sections.
enable voice_vlan
Purpose
Used to enable the global voice VLAN function.
Syntax enable voice_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
Description
This command is used to enable the global voice VLAN function on the Switch. To enable
the voice VLAN, the voice VLAN must be assigned to an existing static 802.1Q VLAN. The
VLAN with assigned voice VLAN cannot be deleted. To change the voice VLAN, the user
must disable the voice VLAN function first, and then re-issue this command. By default, the
global voice VLAN state is disabled.
Parameters <vlan_name 32> - Specifies the voice VLAN by VLAN name.
vlanid <vlanid 1-4094> - Specifies the voice VLAN by VLAN ID.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To enable a voice VLAN:
DES-3528:admin# enable voice_vlan vlanid 1
Command: enable voice_vlan vlanid 1
Success.
DES-3528:admin#

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English