xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
71
Network Monitoring Commands
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilization [ports | cpu]
show utilization dram {unit <unit_id>}
show utilization flash {unit <unit_id>}
clear cou
nters
{ports <por
tlist>
} clear log
show log {[index <value_list> |severity {module <module_list>} {emergency | alert | critical |
error | warning | notice | informational | debug | <level_list 0-7>} | module
<module_list>]}
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency | alert | critical |
error | warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
state [enable | disable]}
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning | notice |
informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr>
|<ipv6addr>] | state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
show attack_log {unit <unit_id 1-8>} {index <value_list>}
clear attack_log {[unit <unit_id 1-8> | all]}
config system_severity [trap | log | all] [emergency | alert | critical | error | warning | notice | information |
debug | <level 0-7>]
show system_severity
Each command is listed, in detail, in the following sections.
To Next Page
Loading...
Need help?
General