D-Link xStack DES-3528 Series - Page 70

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
70
config configuration
Purpose
Used to delete the specific firmware or configure the specific firmware as boot up image.
Syntax config configuration <config_id 1-2> [boot_up | delete | active]
Description
This command is used to delete the specific firmware or configure the specific firmware as
boot up image.
Parameters
<config_id 1-2> − Specifies the serial number of the indicated configuration.
boot_up − Specifies the config is boot_up config.
delete − Delete the configuration.
active − Active specifies the configuration .
Restrictions
You must have Administrator-level privileges.
Example usage:
To configure the specific configuration as boot up image:
DES-3528:admin# config configuration 2 boot_up
Command: config configuration 2 boot_up
Success.
DES-3528:4#