xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
40
Stacking Commands
The stacking configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
config box_priority current_box_id <value 1-8> priority <value 1-63>
config box_id current_box_id <value 1-8> new_box_id [auto | <value 1-8>]
show stack_information
config stacking_mode [disable(0) | enable(1)]
show stacking_mode
show stack_device
config stacking force_master_role state [enable | disable]
Each command is listed, in detail, in the following sections.
config box_priority
Purpose
Used to configure box priority so as to determine which box (Switch) becomes the
master. A lower number denotes a higher priority.
Syntax config box_priority current_box_id <value 1-8> priority <value 1-63>
Description
This command is used to configure the box (Switch) priority.
Parameters current_box_id <value 1–8> – Identifies the Switch being configured. Range is 1 to 8.
priority <value 1–63> – Assigns a priority value to the box. A Lower number denotes a
higher priority. The valid priority range is 1 to 63.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Usage example:
To configure box priority:
config box_id
Purpose
Used to configure box ID. Users can use this command to reassign box IDs.
Syntax config box_id current_box_id <value 1-8> new_box_id <value 1-8> new_box_id
[auto | <value 1-8>]
Description
This command is used to assign box IDs to Switches in a stack.
Parameters current_box_id – Identifies the Switch being configured. Range is 1 to 8.
new_box_id – The new ID being assigned to the Switch (box). Range is 1 to 8.
• auto – Allows the box ID to be assigned automatically.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Usage example:
To change a box ID:
To Next Page
Loading...
