D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
41
DES-3528:admin#
show stack_information
Purpose
Used to display the stack information table.
Syntax show stack_information
Description
This command display stack information.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Usage example:
To display stack information:
DES-3528:admin# show stack_information
Command: show stack_information
Topology :Duplex_Chain
My Box ID :1
Master ID :1
Box Count :1
Force Master Role: Disabled
Box User Prio- Prom Runtime H/W
ID Set Type Exist rity MAC version version version
--- ---- ------------- ----- ---- ----------------- --------- --------- --------
1 Auto DES-3528 Exist 32 00-22-B0-10-8A-00 1.00.B008 3.00.012 A2
2 - NOT_EXIST No
3 - NOT_EXIST No
4 - NOT_EXIST No
5 - NOT_EXIST No
6 - NOT_EXIST No
7 - NOT_EXIST No
8 - NOT_EXIST No
DES-3528:admin#
config stacking_mode
Purpose
Used to configure the stacking mode.
Syntax config stacking_mode [disable(0) | enable(1)]
Description
This command will enable or disable the stacking mode for the Switch. When enabled,
the last two ports on the rear of the Switch will be enabled for stacking.
Parameters enable | disable – Use these parameters to enable or disable the stacking mode for the
Switch. Once this command is executed, it will cause the Switch to reboot. Before
configuring the stacking mode of a Switch to disable status, the Switch must be
physically removed from the stacking switches.
Restrictions
Only Administrator-level users can issue this command.
Usage example:
To disable the stacking mode:
DES-3528:admin# config stacking_mode disable
Command: config stacking_mode disable
Change Box bootmode may cause devices work restart, still continue? (y/n)y

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English