xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
562
Show Technical Support Commands
The Show Technical Support commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
show tech_support
upload tech_support_toTFTP <ipaddr> <path_filename 64>
Each command is listed, in detail, in the following sections.
show tech_support
Purpose
This command is especially used by the technical support personnel to dump the device
overall operation information.
Syntax show tech_support
Description
The information is project dependent and includes the following information.
• Basic System information
• System log
• Running configuration
• Layer 1 information
• Layer 2 information
• Layer 3 information
• Application
• OS status
• Controller’s status
This command can be interrupted by Ctrl - C or ESC when it is executing.
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To show the information of technique’s support:
To Next Page
Loading...
