D-Link xStack DES-3528 Series - MAC-Based Access Control Commands

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
424
MAC-based Access Control Commands
The MAC-based Access Control Commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameters
enable mac_based_access_control
disable mac_based_access_control
config mac_based_access_control
password
<passwd 16>
config mac_based_access_control method
[local | radius]
config mac_based_access_control
guest_vlan ports
<portlist>
config mac_based_access_control ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min 1-
1440>] | block_time <sec 0-300> | max_users [<value 1-1000> |
no_limit]}
config mac_based_access_control trap
state
[enable | disable]
config mac_based_access_control log
state
[enable | disable]
create mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1–4094>]
delete mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1–4094>]
clear mac_based_access_control
auth_state
[ports [all | portlist] | mac_addr <macaddr>]
create mac_based_access_control_local
mac
<macaddr> [vlan <vlan_name 32> | vlanid <vlanid 1–4094>]
config mac_based_access_control_local
mac
<macaddr> [vlan <vlan_name 32> | vlanid <vlanid 1–4094> |
clear_vlan]
delete mac_based_access_control_local [mac <macaddr> | vlan <vlan_name 32> | vlanid <vlanid 1–4094>]
show mac_based_access_control {ports {<portlist> }}
show mac_based_access_control_local {[mac<macaddr> | [vlan <vlan_name 32>|vlanid <vlanid 1–4094>]]}
show mac_based_access_control
auth_state ports
config mac_based_access_control
authorization atrributes
{radius [enable | disable] | local [enable | disable]}(1)
config mac_based_access_control
max_users
[<value 1 - 1000> | no_limit]}
config mac_based_access_control
password_type
[manual_string | client_mac_address]
Each command is listed, in detail, in the following sections.