D-Link xStack DES-3528 Series - Page 425

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
425
enable mac_based_access_control
Purpose
Used to enable MAC-based Access Control.
Syntax enable mac_based_access_control
Description
This command will enable the MAC-based AC function.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage
To enable MAC-based AC function:
DES-3528:admin# enable mac_based_access_control
Command: enable mac_based_access_control
Success.
DES-3528:admin#
disable mac_based_access_control
Purpose
Used to disable MAC-based AC.
Syntax disable mac_based_access_control
Description
This command will disable the MAC-based AC function.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage
To disable MAC-based AC function:
DES-3528:admin# disable mac_based_access_control
Command: disable mac_based_access_control
Success.
DES-3528:admin#
config mac_based_access_control password
Purpose
Used to configure the password of the MAC-based AC.
Syntax config mac_based_access_control password <passwd 16>
Description
This command will set the password that will be used for authentication via RADIUS server.
Parameters
<passwd 16> – In RADIUS mode, the Switch communicate with RADIUS server use the
password. The maximum length of the key is 16.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage
To configure MAC-based AC password:
DES-3528:admin# config mac_based_access_control password switch
Command: config mac_based_access_control password switch
Success.
DES-3528:admin#