D-Link xStack DES-3528 Series - VLAN Commands

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
123
VLAN Commands
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create vlan <vlan_name 32> tag <vlanid 2-4094> {type [1q_vlan | private_vlan]}
{advertisement}
create vlan vlanid <vidlist> {type [1q_vlan | private_vlan]} {advertisement}
delete vlan <vlan_name 32>
delete vlan vlanid <vidlist>
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete] <portlist> |
advertisement [enable | disable]}(1)
config vlan vlanid <vidlist> {[ add [ tagged | untagged | forbidden ] | delete ] <portlist> |
advertisement [ enable | disable ] | name <vlan_name 32>}(1)
config port_vlan [<portlist> | all] { gvrp_state [enable | disable] | ingress_checking [enable | disable]
| acceptable_frame[tagged_only | admit_all] | pvid<vlanid 1-4094> }(1)
enable gvrp
disable gvrp
show vlan { [<vlan_name 32> | vlanid < vidlist > | ports {<portlist>}]}
show port_vlan {<portlist>}
create dot1v_protocol_group
group_id
<id> {group_name <name 32>}
config dot1v_protocol_group [group_id <id> | group_name <name 32>] [add protocol [ethernet_2 |
ieee802.3_snap | ieee802.3_llc] <protocol_value> | delete protocol [ethernet_2 |
ieee802.3_snap | ieee802.3_llc] <protocol_value>]
delete dot1v_protocol_group [group_id <id> | group_name <name 32> | all]
show dot1v_protocol_group {[group_id <id> | group_name <name 32>]}
config port dot1v ports [<portlist> | all] [add protocol_group [group_id <id> | group_name <name 32>]
[vlan <vlan_name 32> | vlanid <id>] {priority <value 0-7>} | delete protocol_group
[group_id <id> | all]]
show port dot1v {ports <portlist>}
enable pvid auto_assign
disable pvid auto_assign
show pvid auto_assign
config gvrp [timer [join | leave | leaveall] < value 100-100000> | nni_bpdu_addr [dot1d |
dot1ad]]
show gvrp
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist> | all] state [enable | disable]
show vlan_trunk
config private_vlan [<vlan_name 32> | vid <vlanid 1-4094>] [add [isolated | community] | remove]
[<vlan_name 32> | vlanid <vidlist>]