xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
587
UDP Helper Commands
The UDP Helper Commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config udp_helper add ipif <ipif_name 12> <ipaddr>
config udp_helper delete
ipif
<ipif_name 12> <ipaddr>
config udp_helper udp_port
add
[time | tacacs | dns | tftp | netbios-ns | netbios-ds | <port_number 0-65535>]
config udp_helper udp_port
delete
[time | tacacs | dns | tftp | netbios-ns | netbios-ds | <port_number 0-65535>]
enable udp_helper
disable udp_helper
show udp_helper {[udp_port | ipif <ipif_name 12>]}
Each command is listed, in detail, in the following sections.
config udp_helper add ipif
Purpose
This command is used to add a UDP helper server address for specific interface of the
Switch.
Syntax config udp_helper add ipif <ipif_name 12> <ipaddr>
Description
This command is used to add a UDP helper server address for specific interface of the
Switch.
Parameters <ipif_name 12> - Enter the name of the IP interface that receives UDP broadcast.
<ipaddr> - Enter the UDP helper server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example usage:
To add a server address for System interface:
config udp_helper delete ipif
Purpose
This command is used to delete a UDP helper server address for specific interface of the
Switch.
Syntax config udp_helper delete ipif <ipif_name 12> <ipaddr>
Description
This command is used to delete a UDP helper server address for specific interface of the
Switch.
Parameters <ipif_name 12> - Enter the name of the IP interface that receives UDP broadcast.
<ipaddr> - Enter the UDP helper server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example usage:
To delete a server address for System interface:
To Next Page
Loading...
Need help?
General