D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
417
Simple RED Commands
The Simple RED commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
enable sred
disable sred
config sred [<portlist> | all] [<class_id 0-7> | all] { threshold {low <value 0-100> | high<value 0-
100>}(1) | drop_rate {low<value 1-8> | high<value 1-8>}(1) | drop_green [enable |
disable]}(1)
show sred { <portlist>{ <class_id 0-7>}}
show sred drop_counter {<portlist>}
config dscp trust [<portlist> | all] state [enable | disable]
show dscp trust {<portlist>}
config dscp map {[<portlist> | all]} [dscp_priority <dscp_list> to <priority 0-7> | dscp_dscp <dscp_list> to
<dscp 0-63> | dscp_color <dscp_list> to [green | red | yellow]]
show dscp map { <portlist> } [dscp_priotity | dscp_dscp | dscp_color] {dscp <dscp_list>}
config 802.1p map {[<portlist> | all]} 1p_color <priority_list> to [green | red | yellow]
show 802.1p map
1p_color
{ <portlist>}
Each command is listed, in detail, in the following sections.
enable sred
Purpose
Used to enable the simple RED function.
Syntax enable sred
Description
This command is usded to enable the sRED function. By default, sRED is disabled.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage
To enable sred:
DES-3528:admin# enable sred
Command: enable sred
Success.
DES-3528:admin#
disable sred
Purpose
Used to disable the simple RED function.
Syntax disable sred
Description
This command is used to disable the sRED function.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage
To disable sred:

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English