D-Link xStack DES-3528 Series - Page 72

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
72
show packet ports
Purpose
Used to display statistics about the packets sent and received by the Switch.
Syntax show packet ports <portlist>
Description
This command is used to display statistics about packets sent and received by ports
specified in the <portlist>.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions
None.
Example usage:
To display the packets analysis for port 2
DES-3528:admin# show packet port 2
Command: show packet port 2
Port Number : 2
===============================================================
Frame Size/Type Frame Counts Frames/sec
--------------- ------------ -----------
64 0 0
65-127 0 0
128-255 0 0
256-511 0 0
512-1023 0 0
1024-1518 0 0
Unicast RX 0 0
Multicast RX 0 0
Broadcast RX 0 0
Frame Type Total Total/sec
--------------- ------------ -----------
RX Bytes 0 0
RX Frames 0 0
TX Bytes 0 0
TX Frames 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show error ports
Purpose
Used to display the error statistics for a range of ports.
Syntax show error ports <portlist>
Description
This command will display all of the packet error statistics collected and logged by the Switch
for a given port list.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions
None.
Example usage:
To display the errors of the port 3:
DES-3528:admin# show error ports 3
Command: show error ports 3
Port Number : 3
RX Frames TX Frames
--------- ---------
CRC Error 0 Excessive Deferral 0
Undersize 0 CRC Error 0