D-Link xStack DES-3528 Series - Page 434

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
434
config mac_based_access_control max_users
Purpose
Used to configure the maximum number of authorized clients.
Syntax config mac_based_access_control max_users [<value 1-1000> | no_limit]
Description
The setting is a global limitation on the maximum number of users that can be learned via
MAC-based AC.
In addition to the global limitation, the per port maximum number of users is also limited. It is
specified by config config mac_based_access_control ports max_users.
Parameters <value 1-1000> – Specifies to set the max number of authorized clients on the whole device.
no_limit – Specifies to not limit the system’s maximum number of users. The default is 128.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the MAC-based AC maximum number of users:
DES-3528:admin# config mac_based_access_control max_users 126
Command: config mac_based_access_control max_users 126
Success.
DES-3528:admin#
config mac_based_access_control password_type
Purpose
This command is used to configure the type of RADIUS authentication password for MAC-
based Access Control.
Syntax config mac_based_access_control password_type [manual_string |
client_mac_address]
Description
This command is used to configure the type of RADIUS authentication password for MAC-
based Access Control.
Parameters manual_string - Specifies to use the same string as password for all clients do RADIUS
authentication, the string can be configured by using the command “config
mac_based_access_control password”.
client_mac_address - Specifies to use the client’s MAC address as the password for
RADIUS authentication. The MAC address format can be configured by using the command
“config authentication mac_format”.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the MAC-based Access Control using client’s MAC address as authentication password:
DES-3528:admin#config mac_based_access_control password_type client_mac_address
Command: config mac_based_access_control password_type client_mac_address
Success.
DES-3528:admin#
To configure the MAC-based Access Control using “manual_string” as authentication password:
DES-3528:admin#config mac_based_access_control password_type manual_string
Command: config mac_based_access_control password_type manual_string
Success.
DES-3528:admin#