xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
184
Command Parameters
show mld_snooping
multicast_vlan_group
{< vlan_name 32> }
delete mld_snooping multicat_vlan <vlan_name 32>
enable mld_snooping multicast_vlan
disable mld_snooping multicast_vlan
show mld_snooping multicast_vlan {<vlan_name 32>}
config mld_snooping multicast_vlan
forward_unmatched
[disable | enable]
Each command is listed, in detail, in the following sections.
create igmp_snooping multicast_vlan
Purpose
Used to create a multicast VLAN
Syntax create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094>
{remap_priority [<value 0-7> | none] { replace_priority}}
Description
This command will create a multicast_vlan. Multiple multicast VLANs can be configured.
When creating an ISM VLAN, it cannot duplicate with the VLAN entries in the existing
802.1Q VLAN database. The ISM VLAN snooping function can co-exist with the 1Q VLAN
snooping function.
Parameters
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given a name
that can be up to 32 characters.
vlanid – The VLAN ID of the multicast VLAN to be create. The range is 2-4094.
remap_priority – The remap priority value (0 to 7) is associated with the data traffic to be
forwarded on the multicast VLAN. If None is specified, the packet’s original priority will be
used.The default setting is none.
replace_priority - Specifies that packet’s priority will be changed by the Switch based on the
remap priority. This flag will only take effect when remap priority is set.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To create IGMP snoop multicast VLAN mv12:
To Next Page
Loading...
