xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
203
config igmp_snooping querier
enable - Enter enable to enable this state.
disable - Enter disable to disable this state.
version - (Optional) Specify the version of IGMP packet that will be sent by this port. If an
IGMP packet received by the interface has a version higher than the specified version, this
packet will be dropped.
<value 1-3> - Enter the version number here. This value must be between 1 and 3.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the IGMP snooping querier:
DES-3528:admin# config igmp_snooping querier vlan_name default query_interval 125
state enable
Command: config igmp_snooping querier vlan_name default query_interval 125 state
enable
Success.
config router_ports
Purpose
This command allows you to designate a range of ports as being connected to multicast-
enabled routers.
Syntax config router_ports [<vlan_name 32> | vlanid <vlanid_list> ] [add | delete] <portlist>
Description
This will ensure that all packets with such a router as its destination will reach the multicast-
enabled router, regardless of protocol, etc.
Parameters <vlan_name 32> - Specify the name of the VLAN on which the router port resides.
vlanid - Specify the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID here.
add - Specify to add the router ports.
delete - Specify to delete the router ports.
<portlist> - Specify a range of ports to be configured. (UnitID:port number)
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To set up static router ports:
DES-3528:admin# config router_ports default add 2:1-2:10
Command: config router_ports default add 2:1-2:10
Success.
To Next Page
Loading...
