D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
219
DES-3528:admin# show mld_snooping
Command: show mld_snooping
MLD Snooping Global State : Disabled
Data Driven Learning Max Entries : 128
VLAN Name : default
Query Interval : 125
Max Response Time : 10
Robustness Value : 2
Last Listener Query Interval : 1
Querier State : Disable
Querier Role : Non-Querier
Querier IP : ::
Querier Expiry Time : 0 secs
State : Disable
Fast Done : Disable
Report Suppression : Enable
Rate Limit : No Limitation
Version : 2
Data Driven Learning State : Enable
Data Driven Learning Aged Out : Disable
Data Driven Group Expiry Time : 260
Total Entries: 1
DES-3528:admin#
show mld_snooping group
Purpose
This command displays the current MLD snooping group information on the Switch.
Syntax show mld_snooping group {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports
<portlist>] {<ipv6addr>}} {data_driven}
Description
This command displays the current MLD snooping group information on the Switch.
Parameters vlan - (Optional) Specify the name of the VLAN for which you want to view MLD snooping
group information. If VLAN and ports and IP address are not specified, the system will
display all current IGMP snooping group information.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - (Optional) Specify the ID of the VLAN for which you want to view MLD snooping
group information.
<vlanid_list> - Enter the VLAN ID list here.
ports - (Optional) Specify a list of ports for which you want to view MLD snooping group
information.
<portlist> - Enter the list of port here.
<ipv6addr> - (Optional) Specify the group IPv6 address for which you want to view MLD
snooping group information.
data_driven - (Optional) Display the data driven groups.
Restrictions
None.
Example usage:
To show an MLD snooping group when MLD v2 is supported:
The first item means that for ports 1-2, the data from the 2001::1/FE1E::1 will be forwarded.
The second item means that for port 3, the data from the 2002::2/FE1E::1 must not be forwarded.
The third item means that for ports 4-5, the data from FE1E::2 will be forwarded, MLD v1 group doesn't care
about the source address.