D-Link xStack DES-3528 Series - Page 264

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
264
Command Parameters
0xffffffff> | offset_64-79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff> } | ipv6 {class <value 0-255> | flowlabel <hex 0x0-0xfffff> | source_ipv6
<ipv6addr> | destination_ipv6 <ipv6addr>}] port [<portlist> | all] [permit | deny]
{time_range <range_name 32>} | delete access_id <value 1-100>]
show cpu
access_profile
profile_id <value 1-5>
config flow_meter [profile_id <value 1-14> | profile_name <name 1-32>] access_id <value 1-128> [rate
[<value 0-1048576>] {burst_size [<value 0-16384>]} rate_exceed [drop_packet |
remark_dscp <value 0-63>] | tr_tcm cir <value 0-1048576> {cbs <value 0-16384>} pir
<value 0-1048576> {pbs <value 0-16384>} {conform [permit | replace_dscp <value 0-
63>] {counter [enable | disable]}} exceed [permit {replace_dscp <value 0-63>} | drop]
{counter [enable | disable]} violate [permit {replace_dscp <value 0-63>} | drop] {counter
[enable | disable]} | sr_tcm cir <value 0-1048576> cbs <value 0-16384> ebs <value 0-
16384> {conform [permit | replace_dscp <value 0-63>] {counter [enable | disable]}}
exceed [permit {replace_dscp <value 0-63>} | drop] {counter [enable |disable]} violate
[permit {replace_dscp <value 0-63>} | drop] {counter [enable |disable]} | delete]
show flow_meter {[profile_id <value 1-14> | profile_name <name 1-32>] {access_id <value1-128>}}
config time_range <range_name 32> [ hours start_time < time hh:mm:ss > end_time< time hh:mm:ss >
weekdays <daylist> | delete]
show time_range
show current_config
access_profile
Each command is listed in detail in the following sections.