D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
271
NOTE: Address Resolution Protocol (ARP) is the standard for finding a host's hardware address (MAC
Address). However, ARP is vulnerable as it can be easily spoofed and utilized to attack a LAN (known
as ARP spoofing attack). For a more detailed explaination on how ARP protocol works and how to
employ D-Link’s advanced unique Packet Content ACL to prevent an ARP spoofing attack, please see
Appendix B, at the end of this manual.
show access_profile
Purpose
Used to display the currently configured access profiles on the Switch.
Syntax show access_profile {profile_id <value 1-14> | profile_name <name 1-32 >}
Description
This command is used to display the currently configured access profiles.
Parameters profile_id <value 1-14> – Specify the profile id to display only the access rules configuration
for a single profile ID. The user may enter a profile ID number between 1 and 14, yet,
remember only 14 access profiles can be created on the Switch.
profile_name <name 1-32 > – Specifies the name of the profile. The maximum length is 32
characters.
Restrictions
None.
Example usage:
To display all of the currently configured access profiles on the Switch:
DES-3528:admin#show access_profile
Command: show access_profile
Access Profile Table
Total User Set Rule Entries : 0
Total Used HW Entries : 1
Total Available HW Entries : 1791
================================================================================
Profile ID: 15 Profile name: System
Consumed HW Entries : 14
================================================================================
================================================================================
Profile ID: 16 Profile name: IPv4 Route
Consumed HW Entries : 1
================================================================================
DES-3528:admin#