D-Link xStack DES-3528 Series - Page 32

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
32
Example usage:
To configure the speed of ports 1-3 of unit 1 to be 10 Mbps, full duplex, learning enabled, state enabled and
flow control enabled:
DES-3528:admin# config ports 1-3 speed 10_full learning enable state enable
flow_control enable
Command: config ports 1-3 speed 10_full learning enable state enable flow_control
enable
Success.
DES-3528:admin#
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax show ports {<portlist>} {[description | err_disabled | details | media_type]}
Description
This command is used to display the current configuration of a range of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
description – Adding this parameter to the show ports command indicates that a previously
entered port description will be included in the display.
err_disabled – Use this to list disabled ports including connection status and reason for being
disabled.
details – Use this to show the detail information of ports.
media_type – Specifies the media type used.
Restrictions
None.
Example usage:
To display the configuration of all ports on a Switch:
DES-3528:admin# show ports
Command: show ports
Port State/ Settings Connection Address
MDIX Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------- -------- --------------------- ---------------------- ---------
1 Enabled Auto/Disabled Link Down Enabled
Auto
2 Enabled Auto/Disabled Link Down Enabled
Auto
3 Enabled Auto/Disabled Link Down Enabled
Auto
4 Enabled Auto/Disabled Link Down Enabled
Auto
5 Enabled Auto/Disabled Link Down Enabled
Auto
6 Enabled Auto/Disabled Link Down Enabled
Auto
7 Enabled Auto/Disabled Link Down Enabled
Auto
8 Enabled Auto/Disabled Link Down Enabled
Auto
9 Enabled Auto/Disabled Link Down Enabled
Auto
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
Example usage:
To display the configuration of all ports on a standalone Switch, with description:
DES-3528:admin# show ports description
Command: show ports description