D-Link xStack DES-3528 Series - Page 323

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
323
DES-3528:admin#
show iproute
Purpose
Used to display the Switch’s current IP routing table.
Syntax show iproute {<network_address> | <ipaddr>} {static}
Description
This command will display the Switch’s current IP routing table.
Parameters <network_address> - Enter the network address used here.
<ipaddr> - Enter the IP address used here.
static – Specifies to display all the static routes.
Restrictions
None.
Example usage:
To display the contents of the IP routing table:
DES-3528:admin# show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Cost Protocol
------------------ --------------- ------------ -------- --------
10.0.0.0/8 0.0.0.0 System 1 Local
Total Entries : 1
DES-3528:admin#