xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
344
delete authen server_group
Purpose
Used to delete a user-defined authentication server group.
Syntax delete authen server_group <string 15>
Description
This command will delete an authentication server group.
Parameters
<string 15> − Enter an alphanumeric string of up to 15 characters to define the previously
created server group to be deleted.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To delete the server group “group_1”:
DES-3528:admin# delete server_group group_1
Command: delete server_group group_1
Success.
show authen server_group
Purpose
Used to show the authentication server groups.
Syntax show authen server_group <string 15>
Description
This command will display authentication server groups currently configured on the Switch.
This command will display the following fields:
Group Name: The name of the server group currently configured on the Switch, including
built in groups and user defined groups.
IP Address: The IP address of the server host.
Protocol: The authentication protocol used by the server host.
Parameters
<string 15> − Enter an alphanumeric string of up to 15 characters to define the previously
created server group to be viewed.
Entering this command without the <string> parameter will display all authentication server
groups on the Switch.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To view authentication server groups currently set on the Switch.
DES-3528:admin# show authen server_group
Command: show authen server_group
Group Name IP Address Protocol
--------------- -------------- --------
mix_1 10.1.1.222 TACACS+
10.1.1.223 TACACS
radius 10.1.1.224 RADIUS
tacacs 10.1.1.225 TACACS
tacacs+ 10.1.1.226 TACACS+
xtacacs 10.1.1.227 XTACACS
Total Entries : 5
To Next Page
Loading...
