xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
363
show sim
Purpose
Used to view the current information regarding the SIM group on the Switch.
Syntax show sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group
{commander_mac <macaddr>}] | neighbor]}
Description
This command will display the current information regarding the SIM group on the Switch,
including the following:
SIM Version − Displays the current Single IP Management version on the Switch.
Firmware Version − Displays the current Firmware version on the Switch.
Device Name − Displays the user-defined device name on the Switch.
MAC Address − Displays the MAC Address of the Switch.
Capabilities – Displays the type of Switch, be it Layer 2 (L2) or Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State – Displays the current Single IP Management State of the Switch, whether it be
enabled or disabled.
Role State – Displays the current role the Switch is taking, including Commander, Member or
Candidate. A Stand-alone Switch will always have the commander role.
Discovery Interval − Time in seconds the Switch will send discovery packets out over the
network.
Hold time – Displays the time in seconds the Switch will hold discovery results before
dropping it or utilizing it.
Parameters
candidates <candidate_id 1-100> − Entering this parameter will display information
concerning candidates of the SIM group. To view a specific candidate, include that
candidate’s ID number, listed from 1 to 100.
members <member_id 1-32> − Entering this parameter will display information concerning
members of the SIM group. To view a specific member, include that member’s id number,
listed from 1 to 32.
group {commander_mac <macaddr>} − Entering this parameter will display information
concerning the SIM group. To view a specific group, include the commander’s MAC address
of the group.
neighbor – Entering this parameter will display neighboring devices of the Switch. A SIM
neighbor is defined as a Switch that is physically connected to the Switch but is not part of
the SIM group. This screen will produce the following results:
Port – Displays the physical port number of the commander Switch where the uplink
to the neighbor Switch is located.
MAC Address – Displays the MAC Address of the neighbor Switch.
Role – Displays the role(CS, CaS, MS) of the neighbor Switch.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To show the SIM information in detail:
To Next Page
Loading...
