D-Link xStack DES-3528 Series - Page 365

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
365
Example usage:
To connect to the MS, with member ID 2, through the CS, using the command line interface:
DES-3528:admin# reconfig member_id 2
Command: reconfig member_id 2
DES-3528:admin#
Login:
config sim_group
Purpose
Used to add candidates and delete members from the SIM group.
Syntax config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
Description
This command is used to add candidates and delete members from the SIM group by ID
number.
Parameters
add <candidate_id> <password> − Use this parameter to change a candidate Switch (CaS) to
a member Switch (MS) of a SIM group. The CaS may be defined by its ID number and a
password (if necessary).
delete <member_id 1-32> − Use this parameter to delete a member Switch of a SIM group.
The member Switch should be defined by ID number.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To add a member:
DES-3528:admin# config sim_group add 2
Command: config sim_group add 2
Please wait for ACK!!!
SIM Configure Success !!!
Success.
DES-3528:admin#
To delete a member:
DES-3528:admin# config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK!!!
SIM Configure Success!!!
DES-3528:admin#
reconfig
Purpose
Used to connect to a member Switch, through the commander Switch, using Telnet.
Syntax reconfig [member_id <value 1-32> | exit]
Description
This command is used to reconnect to a member Switch using Telnet.
Parameters
member_id <value 1-32> − Select the ID number of the member Switch to configure.
exit – This command is used to exit from managing the member Switch and will return to
managing the commander Switch.
Restrictions
Only Administrator-level users can issue this command.