D-Link xStack DES-3528 Series - Page 402

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
402
DES-3528:admin#config lldp_med ports 1:1-1:2 med_transmit_capabilities all state
enable
Command: config lldp_med ports 1:1-1:2 med_transmit_capabilities all state enable
Success.
DES-3528:admin#
show lldp_med
Purpose
This command is used to display the switch’s general LLDP-MED configuration status.
Syntax show lldp_med
Description
This command is used to display the switch’s general LLDP-MED configuration status.
Parameters
None.
Restrictions
None.
Usage Example:
To display the switch’s general LLDP-MED configuration status:
DES-3528:admin#show lldp_med
Command: show lldp_med
LLDP-MED System Information:
Device Class : Network Connectivity Device
Hardware Revision : A5
Firmware Revision : 1.00.B008
Software Revision : 3.00.005
Serial Number : PVZU1BB000141
Manufacturer Name : D-Link
Model Name : DES-3528 Fast Ethernet Switch
Asset ID :
PoE Device Type : PSE Device
PoE PSE Power Source : Primary
LLDP-MED Configuration:
Fast Start Repeat Count : 5
LLDP-MED Log State:Enabled
DES-3528:admin#
show lldp_med local_ports
Purpose
This command is used to display the per-port LLDP-MED information currently available for
populating outbound LLDP-MED advertisements.
Syntax show lldp_med local_ports {<portlist>}
Description
This command is used to display the per-port LLDP-MED information currently available for
populating outbound LLDP-MED advertisements.
Parameters <portlist> - Specifies a range of ports to be displayed.
Restrictions
None.
Usage Example:
To display LLDP-MED information currently available for populating outbound LLDP-MED advertisements for
port 1:
DES-3528:admin#show lldp_med local_ports 1:1
Command: show lldp_med local_ports 1:1
Port ID : 1:1